50
TOYOTA SAFETY SENSE
™
ACTIVATING CRUISE CONTROL
Vehicle will cruise at a set vehicle speed.
(1) Press “
” switch to select “Cruise Control Mode.” The cruise control indicator
“
” will illuminate.
(2) Using the accelerator pedal, accelerate or decelerate to the desired vehicle
speed (approximately 20 mph [30 km/h] or more), and press “
” switch to
set the set vehicle speed. The set vehicle speed will be displayed on the Multi-
Information Display (MID).
ADJUSTING SET VEHICLE SPEED
(3) To change the set vehicle speed, press the “+” (increase) or “-” (decrease)
switch until the desired speed is displayed. Press and hold to continuously
adjust the speed in 1 mph (1.6 km/h) increments, or use a single press to adjust
in individual increments of 1 mph (1.6 km/h).
(4) Press “
” switch or “ ” switch to cancel the speed control.
(Press the “
” switch to resume control.)
*
The speed control may also be canceled by depressing the brake pedal.
Note: NOTE: On steep downhills, or where there are sudden changes between
sharp up and down gradients, vehicle speed may exceed the set speed when
driving down a steep hill.
Refer to the Toyota “Owner’s Manual” for additional information on Cruise Control
operation, settings adjustments, limitations, and precautions before attempting to
use it.
(1) (2)
Set vehicle speed
Press
(4)
(3)
Cancel
*
Cancel
*
Increase speed/Resume
Decrease speed
To Next Page
Loading...
