Toyota GR Corolla - Page 354

354
8-1. Specifications
■ Oil capacity (Drain and refill
[Reference
*
])
*
: The engine oil capacity is a refer-
ence quantity to be used when
changing the engine oil. When
actually adding the engine oil,
make sure that the oil level is
between the low level mark and
refill upper limit mark (P.269).
Warm up and turn off the engine,
wait more than 8 minutes, and
check the oil level on the dipstick.
■ Engine oil selection
“Toyota Genuine Motor Oil” is
used in your Toyota vehicle. Use
Toyota approved “Toyota Genu-
ine Motor Oil” or equivalent to
satisfy the following grade and
viscosity.
Oil grade: ILSAC GF-6A multi-
grade engine oil
Recommended viscosity:
SAE 0W-20
Outside temperature
SAE 0W-20 is the best choice
for good fuel economy and good
starting in cold weather.
Oil viscosity (0W-20 is explained
here as an example):
• The 0W in 0W-20 indicates
the characteristic of the oil
which allows cold startability.
Oils with a lower value before
the W allow for easier starting
of the engine in cold weather.
• The 20 in 0W-20 indicates the
viscosity characteristic of the
oil when the oil is at high tem-
perature.
How to read oil container label:
The International Lubricant
Specification Advisory Commit-
Fuel
Fuel type Unleaded gasoline only
Octane Rating
91 (Research Octane Number 96) or
higher
Fuel tank capacity
(Reference)
13.2 gal. (50.0 L, 11.0 Imp. gal.)
Lubrication system
With filter
4.5 qt. (4.3 L, 3.7
Imp.qt.)
Without
filter
4.2 qt. (4.0 L, 3.5
Imp.qt.)