Toyota RAV4 PRIME 2023 - Safety Connect

61
SUPPORTED TYPES OF ROAD SIGNS
SYSTEM ON/OFF
Speed limit Stop
Do Not Enter Yield
(1) Press “
” or “ ” switches and select “ (7-in display)” or “ (12.3-in
display)” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ RSA” and then press “ ” to turn RSA
On/Off.
(3) Press “
” to go back to the menu.
Note: If the vehicle was last turned off while a speed limit sign was displayed
on the Multi-Information Display (MID), the same sign displays again when the
vehicle is turned back ON.
OVERVIEWELECTRIC VEHICLE SYSTEMFEATURES & OPERATIONSTOYOTA SAFETY SENSE
SAFETY &
EMERGENCY FEATURES
low beams temporarily.
time. Afterwards, the Automatic High Beams will be activated again.
NOTE: It is recommended to switch to the low beams when the high
may cause problems or distress to other drivers or pedestrians nearby.
Road Sign Assist (RSA)
Assist (RSA) is designed to detect certain road signs and display them on the
instrument cluster.
All vehicle actions must be driver-initiated and are not automated.
Refer to the Toyota “Owner’s Manual” for additional information and limitations.
Vehicles with 7-inch display:
When a tab other than the driving
selected, the following types of road
signs will be displayed.
• Speed limit sign
is necessary)
ADDITIONAL RSA SETTINGS
(1) Press “ ” or “ ” switches and select “ (7-in display)” or “ (12.3-in
display)” from the Multi-Information Display (MID).
(2) Press “
” switches and select “ RSA” and then press and hold “ .”
The setting screen is displayed.
(3) Press “
” switches to select an RSA setting from the menu, and press “ ”
to select or change a desired setting.
(4) Press “
” to go back to the menu.
Refer to the Toyota “Owner’s Manual” for additional information on RSA operation,
settings adjustments, limitations, and precautions before attempting to use it.
MY23_RAV4-PRIME_QRG_V2_ML_0907_PRINT.indd 61 9/13/22 11:46 AM