EasyManua.ls Logo

Toyota RAV4 PRIME 2023 - Road Sign Assist (RSA); SAFETY & EMERGENCY FEATURES; Seat belts

Toyota RAV4 PRIME 2023
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
60
TOYOTA SAFETY SENSE
” or “ ” switches and select (7-in display)” or “ (12.3-in
from the Multi-Information Display (MID).
” switches and select “ RSA” and then press “ ” to turn RSA
” to go back to the menu.
the vehicle was last turned off while a speed limit sign was displayed
Display (MID), the same sign displays again when the
back ON.
TEMPORARILY SWITCHING TO THE LOW BEAMS
Pull the lever toward you and then return it to its original position to switch to the
low beams temporarily.
The high beams are on while the lever is pulled toward you, however, after the lever
is returned to its original position, the low beams remain on for a certain amount of
time. Afterwards, the Automatic High Beams will be activated again.
NOTE: It is recommended to switch to the low beams when the high beams
may cause problems or distress to other drivers or pedestrians nearby.
Road Sign Assist (RSA)
Using the forward-facing camera and navigation system (if equipped), Road Sign
Assist (RSA) is designed to detect certain road signs and display them on the
instrument cluster.
All vehicle actions must be driver-initiated and are not automated.
Refer to the Toyota “Owner’s Manual” for additional information and limitations.
RSA DISPLAY
Vehicles with 7-inch display:
When a tab other than the driving
support system information display is
selected, the following types of road
signs will be displayed.
Speed limit sign
Do Not Enter sign (when notification
is necessary)
Vehicles with 7-inch display:
When the driving support system
information display is selected, a
maximum of 3 signs can be displayed.
Vehicles with 12.3-inch display:
A maximum of 2 signs can be displayed.
7-in display
12.3-in display
” or switches and select (7-in display)” or “ (12.3-in
from the Multi-Information Display (MID).
” switches and select “ RSA” and then press and hold .”
switches to select an RSA setting from the menu, and press
to go back to the menu.
MY23_RAV4-PRIME_QRG_V2_ML_0907_PRINT.indd 60 9/13/22 11:46 AM

Table of Contents

Related product manuals