TOYOTA ─ Remote Engine Starter Page 15
OPERATION (PRIMARY FEATURES)
LONG RANGE REMOTE ENGINE STOP (TYPE A)
To remotely stop the vehicle engine, press the button, and then press the button
within three seconds. The table below describes the complete cycle of stop function.
NORMAL OPERATION
FUNCTION
REMOTE CONTROL CONDITION VEHICLE CONDITION
LED
(LIGHT COLOR)
BUZZER HAZARD LIGHTS ENGINE
REMOTE
CONTROL
OPERATION
Press
Blinking for 3 seconds
Press
Lighting for 2 seconds
No operation
RUN
ENGINE STOP No light No sound
No operation
STOP
ENGINE
STATUS
FEEDBACK
Lighting for 3 seconds
No operation
STOP
NOTE: No buzzer or flashing hazard lights on vehicle when engine stops, but can confirm the engine
stop by the LED feedback and buzzer on remote control.
NOTE: When the engine was started with the ignition key or the push start button, the Remote
Engine Starter cannot stop the engine.
(Green)
(Green)
(Green)
To Next Page
Loading...
