6
Press this button to set up &down swing angle, which circularly changes as below
:
OFF
This remote controller is universal . If any command , or is sent out, the unit will carry
indicates the guide louver swings as:
Press this button to turn on I FEEL function. The unit automatically adjust temperature according to
the sensed temperature. Press this button again to cancel I FEEL function.
I FEEL:
SWING:
7
Remote Controller Description
ON/OFF :
MODE :
+ :
AUTO
C
OO
L
DRY
FAN HEAT
*
*Note:Only for models with heating function.
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed
on the LED of the indoor, and the unit will automatically select the suitable operation mode in
accordance with the room temperature to make indoor room comfortable.
3
This button is used for setting Fan Speed in the sequence that goes from AUTO,
,
FAN
:
1
4
3
2
5
Press this button to turn on the unit .Press this button again to turn off the unit.
Press this button to decrease set temperature. Holding it down above 2 seconds rapidly decreases
set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to increase set temperat
ure.Holding it down above 2 seconds rapidly increases set
Auto
Medium speedLow-Medium speedLow speed
High speedMedium-High speed
Each time you press this button,a mode is selected in a sequence that goes from AUTO, COOL,DRY,
*
, as the following:
to
then back to Auto.
,
,,
How to use the remote control to operate the unit
OPERATION INSTRUCTIONS
temperature. In AUTO mode, set temperature is not adjustable.
FAN,and HEAT
out the command as
To Next Page
Loading...
Need help?
General
