Need help?Do you have a question about the Toyotomi OM-22 and is the answer not in the manual?
General| Model | OM-22 |
|---|---|
| Fuel Type | Kerosene |
| Run Time | 17 hours |
| Fuel Consumption | 0.23 L/h |
| Tank Capacity | 4.0 L |
| Ignition | Manual |
| Type | Portable kerosene heater |
Overview of the Laser Heating System and its physical dimensions.
Details on combustion, burner, igniter, venting, and blower motor.
Description of fuel supply, sump, pump, and electrical system overview.
Explanation of control board, sensors, safety mechanisms, and recovery systems.
Guidelines for heater placement, clearances, and flue pipe drilling.
Details on power needs, fuel tank requirements, and sensor wiring.
Emphasis on building codes and instructions for unpacking the unit.
Steps for installing the heater unit and connecting the fuel line.
Comprehensive guide for fuel tank installation and high altitude use.
Overview of heater operation and performance specifications.
Explanation of control panel functions and pre-operation checklist.
Startup procedures, normal operation, power saver, and temperature adjustments.
Instructions for timer programming and recovery from power failure or overheat.
Overview of maintenance types and a schedule of routine tasks.
Procedures for inspecting air lines and verifying igniter functionality.
Steps for cleaning the fuel inlet strainer and replacing fuses.
Guidance on diagnosing and resolving fuel contamination issues.
Introduction to servicing and cleaning the heat exchanger and burner.
Steps for removing fuel system contaminants and cleaning filters.
Reference for understanding and resolving error codes displayed by the heater.
Overview of the electrical system, schematics, and component values.
Timing charts for operational states and analysis of control board functions.
Step-by-step guides for diagnosing and resolving common operational failures.
List of all heater components with reference numbers for identification.
To Next Page