Quick Installation Guide
AC1750 Wireless Dual Band Gigabit Router
Connect the Hardware
7106505288 REV3.0.0
Verify that the following LEDs are
on and stable before continuing
with the configuration.
5
Note: If the 2.4G LED and 5G LED are off, please
turn on the Wireless On/Off switch on the rear
panel. And 5 seconds later check the LEDs again.
Power
On
System
Flashing
Internet
On/Flashing
2.4G
Flashing
5G
Flashing
Archer C7
4
Turn on the Archer C7.
Power adapter
Power adapter
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the Archer C7’s Internet port.
Modem
Internet
Turn on the modem, and
then wait 2 minutes for
it to restart.
Turn o the modem,
and remove the backup
battery if it has one.
1
3
Connect the modem to the
Internet port on your Archer C7
with an Ethernet cable.
2
To Next Page
