Determine Operation Mode
Refer to the following scenarios to determine an appropriate operation mode.
Mode Switch Operation Mode Scenario
Share ETH Router (Default Mode
The wired network is only limited to one device to connect at a time, but I want to share the internet with
more wireless devices.
Share Hotspot Hotspot
I want to have internet access from a wireless internet service provider (WISP), and share the internet with
local devices.
AP/Rng Ext/Client
Access Point I want to access the internet wirelessly, but only a wired network is available.
Range Extender
I am in a Wi-Fi “dead zone” or a place with a weak wireless signal. I want to have a larger range of wireless
signal for a better internet connection throughout my home or office.
Client
I have a wired-only device, for example, a smart TV, media player, or game console. I want to connect it to
my wireless network.
During Travel
Router Mode (Default)
1. Switch the operation mode to Share ETH and connect the hardware according to Step A to D in the left diagram.
Tips: Plug a 3G/4G USB modem with a SIM/UIM card into the 3G/4G USB port as needed.
2. Connect your device to the router wirelessly. The Wi-Fi network names and passwords are on the router’s label.
Check whether you can access the internet.
– If yes, neglect the steps below and enjoy the internet.
– If no, continue with the steps below.
3. Launch a web browser and enter http://tplinkwifi.net in the address bar. Log in with admin (in lowercase) for both username and password.
4. Click Next to start the Quick Setup.
5. Select your WAN Connection Type. If you are not sure, click Auto Detect. Then follow the screen instructions to continue.
6. Either customize your Wireless Network Name and Password for the 2.4GHz/5GHz wireless network or keep the default ones and then click Next.
7. Click Save to apply the settings.
If you have changed the default Wi-Fi name(s) and password(s), you have to reconnect your wireless devices to the new Wi-Fi network(s).
Hotspot Mode
To Next Page
Loading...
