LEDs:
LED Status Indication
(Power)
On The router is on.
Blinking The router is initializing or being upgraded.
(Internet)
On The internet is available.
Off The internet is unavailable.
(Wireless)
On The wireless network is enabled.
Blinking
The router is connecting to the host network
when in Range Extender or Client mode.
Off The wireless network is disabled.
(USB)
On A USB device is connected.
Off No USB device is connected.
(WPS)
On
This light stays on for 5 minutes when a WPS
connection is established, then goes off.
Blinking WPS connection is in progress.
Off No WPS connection is established.
Buttons and Ports:
Ports Description
Mode Switch This button is used to switch the operation mode of the router.
WAN/LAN
This port functions as the WAN port in Router mode and as the LAN port in Hotspot, Access The point,
Range Extender, and Client mode.
Power The port is used to connect the power adapter.
RESET To reset the router, use a pin to press and hold the button for about 5 seconds.
3G/4G USB This port is used to plug a 3G/4G modem or a USB disk into.
8 (WPS)
To establish a WPS connection, press this button.
For technical support and other information, please visit http://www.tp-link.com/support
©2017 TP-Link
File Downloads
tp-link Installation Guide
AC750 Wi-Fi Travel Router, TL-WR902AC
Download [optimized]
Download
References
To Next Page
Loading...
