Image may dier from your actual product.
AC4000 MU-MIMO Tri-Band Wi-Fi Router
Quick Installation Guide
Connect the Hardware
Modem
Power adapter
Router
Power adapter
Turn on the router.
5
Internet
Turn on the modem, and
then wait about 2 minutes
for it to restart.
Connect the modem to the
Internet port on your router
with an Ethernet cable.
Turn off the modem, and
remove the backup battery
if it has one.
2
4
3
Place the router horizontally and extend the
antennas to the maximum angle.
Note: For best performance, horizontal installation
is recommended.
Antenna’s direction and position can affect
performance in vertical installation situations.
1
On
Internet
5GHz-2
On
Verify that the following LEDs turn solid on before
continuing with the configuration.
5GHz-1
On
Power
On
2.4GHz
On
Notes:
1. If all the LEDs are off, press the LED On/Off button for about 1
second, then check the LEDs again.
2. If the 2.4GHz, 5GHz-1, and 5GHz-2 LEDs are off, press the Wi-Fi
On/Off button for about 1 second, then the three LEDs should
turn solid on.
6
If your internet connection is through an Ethernet cable from the wall instead of
through a DSL / Cable / Satellite modem, connect the Ethernet cable directly to
the router’s Internet port, then follow steps 1, 5 and 6 to complete the hardware
connection.
If you already have a router and want to congure this new router as an access
point to extend your network, refer to the Access Point Mode section on the
back page.
To Next Page
Need help?
General
Weight and Dimensions
