TL-PA211 AV200 Powerline Adapter
21
Join an existing Powerline network:
Powerline adapter A and Powerline adapter B form a HomePlugAV network, Powerline adapter C wants
to join this network.
Step 1. Press and hold the Pair button on Powerline adapter C for 1 second.
Step 2. Within 2 minutes, press and hold the Pair button on Powerline adapter A/B for 1 second.
Step 3. Wait for about 60 seconds while your Powerline adapters are connecting. The Power LED on
Powerline adapter A/B and C will stop flashing and become solid light when the connection is
made.
) Note:
The sequence of Step 1 and Step 2 can be exchanged.
Leave an existing Powerline network:
As the figure above shown, Powerline adapter A, B and C have formed a HomePlugAV network. The
user wants to remove one device (Powerline adapter A) from this network.
Step 1. Press and hold the Pair button on Powerline adapter A for at least 10 seconds. Powerline
adapter A will reset and restart. (The Power LED of Powerline adapter A will momentarily
extinguish during resetting, flash during restarting then illuminate steadily.)
Step 2. Wait for the reset to complete.
To Next Page
Loading...
