30
Configure DSL settings. Enable Bit Swap to
allow your Deco to adapt to the changing
telephone line conditions. Enable SRA to
prevent ADSL data rate interference caused
by the cross-talk between telephone lines.
Note: This feature is available only when your Deco works in
DSL Modem Router mode.
Enable MAC Clone if Deco fails to connect to
the internet.
Tip: For more about MAC Clone, refer to
https://www.tp-link.com/support/faq/2925/
Note: This feature is not available when your Deco works in
Access Point mode.
Enable IPTV/VLAN mode to support IPTV
services.
Note: This feature is not available when your Deco works in
Access Point mode.
To Next Page
Loading...
