TP-Link Omada ER8411 - Configure via Omada Software Controller

Omada VPN Router
12Software Conguration
Option 2 Via Omada Software Controller
The Omada Software Controller is free software for centralized management. To centrally manage
your devices, the Omada Software Controller needs to continually run on your computer.
Figure 4-3 Manage the network via Omada Software Controller
Switch
Router
Clients
EAP EAP EAP
Controller
Omada Software Controller
running on the Host PC
1. On a PC with Windows OS or Linux OS, download the Omada Software Controller installation
file from https://www.tp-link.com/support/download/omada-software-controller/.
Note:
To download Omada Software Controller successfully, it is recommended to configure
the router’s network to access the internet. Refer to Standalone Mode to launch the
management page and go to Network > WAN to complete the configuration.
2. Run the file and follow the wizard to install the Omada Software Controller.
3. Launch the Omada Software Controller and follow the step-by-step instructions to complete
the quick setup.
4. After the quick setup, the login page appears. Enter the username and password you created
and click Log in. Then you can further configure the network.
■
More Management Methods
*
Via Omada Cloud Portal
After installing Omada Software Controller, you can remotely access the controller through
Omada Cloud Portal. Follow the steps below.
a. Enable Cloud Access on the setting page on the controller and bind a TP-Link ID to your
controller. If you have configured this in the setup wizard, skip the step.
b. Launch a web browser and enter https://omada.tplinkcloud.com in the address bar.