English
1
Installation
■
Desktop Installation
To install the device on the desktop, follow the steps below:
*For models without attachable rubber feet, skip steps 3 and 4.
1. If there are detachable antennas, install the antennas
first.
2. Set the device on a flat surface to support the entire
weight of the device with all fittings.
3. Remove the adhesive backing papers from the rubber
feet.
4. Turnover the device and attach the supplied rubber
feet to the recessed areas on the bottom at each
corner of the device.
Feet
Bottom of the device
Notch
■
Rack Installation (Only for Certain Models)
If your device is provided with rack-mountable
brackets, you can install the device in a rack. Follow the
To Next Page
Loading...
