TP-Link PHAROS SERIES - Configure Wireless AP Parameters

94
5.3 &RQILJXUH:LUHOHVV$33DUDPHWHUV
Note:
Wireless Client Settings submenu is only available in Access Point, Bridge, AP Router and AP Client
Router (WISP Client) Mode.
In this section, configure wireless AP parameters used for the connection with the clients.
Go to the :LUHOHVV Page. In the :LUHOHVV$36HWWLQJV section, specify the SSID.
Enable SSID
Broadcast
Enable or disable SSID broadcast. With this function enabled, the device
will broadcast the SSID periodically.
Specify the security mode used for the clients to access the wireless network.
Ђ 1RQH
Select 1RQH when you want an open network without wireless security. In this mode, network
data is not encrypted, but you can still authenticate clients by enabling the RADIUS MAC
Authentication function.