TP-Link RE650 - Connect Devices to Access Point

33
Chapter 6 Use Your Extender as an Acess Point
6. 2. Connect Your Wireless Devices to the
Extender
Method 1: Connect to the extender manually
You can connect your wireless devices to the extender by using the extender’s wireless
network names and passwords.
Method 2: Connect to the extender via WPS
Wi-Fi Protected Setup (WPS) provides an easier way to set up a secure Wi-Fi connection.
Wireless devices that support WPS, including Android phones, tablets and most USB
network cards, can be connected to your extender through this method (not supported
by iOS devices).
1. Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set
for the extender.
2. Go to Settings > Wireless > WPS.
3. Enable WPS.
4. Connect via WPS:
• AP’s PIN: Enable AP’s PIN and enter the PIN on your device. You can click Generate
to get a new PIN or click Default to restore the PIN to its factory one.
• PIN code: Enter the client’s PIN, and click Connect.
• Push Button: Click Connect and push the WPS button on the client device.