34
Chapter 6 Use Your Extender as an Acess Point
6. 3. LED Explanation for the Access Point Mode
When the extender works in the Access Point mode, you can check its working status
by following the LED Explanation table below.
Name Status Indication (For Access Point Mode)
(Signal)
On A WPS connection is established.
Blinking
WPS connection is in progress. This may take up to 2
minutes.
Off
A WPS connection has been established for more than 5
minutes or WPS connection failed.
2.4GHz On/Off The 2.4 GHz wireless band is enabled or disabled.
5GHz On/Off The 5 GHz wireless band is enabled or disabled.
Power
On/Off The extender is on or off.
Blinking The system is starting up or firmware is being upgraded.
To Next Page
Loading...
