13
Power Up Your Camera
After installing your camera, follow the steps below to power up your camera.
1. Firmly plug in the power connector to the power port of the camera,
and ensure no gap exists.
Note:
When plugging in the power connector, you may feel the resistance from the
silicon cork inside the power port because of the waterproof design. It is necessary to
plug in rmly until there is no gap between them.
2. Fix the power cord with adhesive tape or the provided cable clamp
and screw.
Note:
To ensure a firm connection, fix the power cord at a distance of about 25 cm
away from the power connector.
Metallic Surface Wall
Adhesive Tape Cable Clamp & Screw
To Next Page
Loading...
