How to Reset the Plug
Reset Wi-Fi while keeping
previous settings
Press & hold for 5s:
Factory reset the plug
Press & hold for 10s:
Third-Party Services
Tapo works with Alexa, Google
Assistant, Samsung SmartThings, and
other third-party services to control
your smart plug by voice. You can go to
Me > Third-Party Services in the Tapo
app to set up as you need.
Load Type Max Current Max Power (at 120V~)
Iron
15A 1800W
15A
15A
15A
Kettle
Heater
Toaster
Coee Maker
Desk Lamp
TV
1.2A
4A
1800W
80W
1800W
1500W
1200W
350W
PC 7A 600W
FAN 1.4A 120W
Water Pump 1.4A 120W(1/6HP)
Power Adapter/
USB Charger *
2.4A 200W
15A
Supported Load Types
Note:
1. *Power Adapters/USB Chargers rated under 75W do
not support PFC (Power Factor Correction). PFC can
reduce the inrush current generated when the relay is
turned on. Therefore, using a 60-75W Power
Adapter/USB Charger may damage the device due to
inrush currents.
2. Avoid plugging your appliances with a
motor/compressor higher than 1/6HP, such as an air
conditioner. Frequent on/o switching may damage the
compressor. You can check the motor/compressor
value listed on your appliances or consult their Support.
3. EV charging is not supported as it demands higher
power and a charging current that surpasses the plug's
rated capacity.
Please keep this instruction manual.
This is a portable direct plug-in device. Plug the
device into a suitable outlet. This device is intended
for indoor use only. Keep the device away from heat
sources and enclosed spaces with poor ventilation.
Purpose of control: this is operating control.
Operating control, Type 1.B action
Impulse voltage: 1500V
Pollution degree 2 NEMA Type 1 Enclosure
Operation temperature: 0~40°C (32~104°F)
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Rating:
100-125V, 50/60Hz, 15A, General use/Resistive
100-125V, 50/60Hz, 1/6HP, (4.4FLA/26.4LRA),
Motor load
100-125V, 50/60Hz, 8A, Incandescent
Information required in Marking section but not
provided on the device due to limited space.
To Previous Page
Loading...
