5
Charge the Battery
The battery comes partially charged. We recommend that you fully charge the battery before use. This will take about seven and a half hours.
Note:
1. Peel o lm from the camera before use.
2. Warning: Do not tear o the silicone part by force as it may aect the waterproof performance.
3. Charge the battery using the USB cable included in the package. Inappropriate cables may result in slow charging or failure to charge.
4. When you plug in the USB charger, the LED should blink amber quickly for 3 seconds. If not, make sure the power is running and check your connection.
5. The camera may not power up after falling. Plug in the USB charger to power it on again.
6. Keep the ports rmly covered when not in use to ensure waterproof performance.
7. Check the battery status on the Tapo app after setup.
To Next Page
Loading...
