-48-
3.3.1.3 Multi-Nets NAT
Multi-Nets NAT functions to allow the IP under LAN or DMZ port within multiple subnets to access the
Internet via NAT.
Choose the menu Advanced→NAT→Multi-Nets NAT to load the following page.
Figure 3-32 Multi-Nets NAT
The following items are displayed on this screen:
¾ Multi-Nets NAT
Subnet/Mask:
Enter the subnet/mask to make the address range for the entry.
Interface:
Select the interface for the entry. You can select LAN or DMZ port.
Description:
Give a description for the entry.
Status:
Activate or inactivate the entry.
¾ list of Rules
You can view the information of the entries and edit them by the Action buttons.
The first entry in Figure 3-32 indicates that: This is a Multi-Nets NAT entry named tplink1. The subnet
under the LAN port of the router is 192.168.2.0/24 and this entry is activated. After the corresponding
Static Route entry is set, the hosts within this subnet can access the Internet through the router via
NAT.
To Next Page
Loading...
