Report No.: BL-SZ1770154-601
14
/
25
5.2 Receiver Parameters
5.2.1 Receiver Blocking
Limit
While maintaining the minimum performance criteria as defined in clause 4.3.1.12.3, the blocking levels at
specified frequency offsets shall be equal to or greater than the limits defined for the applicable receiver category
provided in table 6, table 7 or table 8.
Receiver Category 1 equipment
Wanted signal mean power from
companion device (dBm)
Blocking signal
frequency(MHz)
Blocking signal
power (dBm)
(see Note
2
)
Type of blocking
signal
Pmin + 6 dB
2380 -53 CW
2 503.5 -53 CW
Pmin + 6 dB
2300 -47 CW
2330 -47 CW
2360 -47 CW
Pmin + 6 dB
2 523.5 -47 CW
2 553.5 -47 CW
2 583.5 -47 CW
2 613.5 -47 CW
2 643.5 -47 CW
2 673.5 -47 CW
Note
1
: Pmin is the minimum level of wanted signal (in dBm) required to meet the minimum performance
criteria as defined in clause 4.3.1.12.3 in the absence of any blocking signal.
Note
2
: The levels specified are levels in front of the UUT antenna. In case of conducted measurements,
the levels have to be corrected by the actual antenna assembly gain.
Receiver Category 2 equipment
Wanted signal mean power from
companion device (dBm)
Blocking signal
frequency(MHz)
Blocking signal
power (dBm)
(see Note
2
)
Type of blocking
signal
Pmin + 6 dB
2380 -57 CW
2 503.5 -57 CW
Pmin + 6 dB
2300 -47 CW
2 583.5 -47 CW
Note
1
: Pmin is the minimum level of the wanted signal (in dBm) required to meet the minimum
performance criteria as defined in clause 4.3.1.12.3 in the absence of any blocking signal.
Note
2
: The levels specified are levels in front of the UUT antenna. In case of conducted measurements,
the levels have to be corrected by the actual antenna assembly gain.
To Next Page
Loading...
