Quick Installation Guide
More: To add additional powerline
adapters and powerline Wi-Fi extenders
with the default settings, simply plug them
into the wall sockets on the same electrical
circuit.
Extender
(TL-WPA4230P)
Adapter
(TL-PA4020P)
Applicable to TL-WPA4230P and its multiple-pack kits
AV500 Passthrough Powerline Wi-Fi Extender
7106505539 REV2.0.1
Plug and Play
Set Up a New Wireless Network
Use the default wireless network name
(SSID) and password on the provided Wi-Fi
Info Card to access the Internet.
Router
1
2
3
4
Enjoy!
* TL-WPA4230P KIT (European version) is used for demonstration in this QIG.
Image may dier from actual product.
Clone Your Router’s Wi-Fi Settings to the Extender (Recommended)
Note: If the Wi-Fi LED still blinks slowly for longer than 30 seconds, unplug the extender and plug
it back in, then try again. Or use “Customize the Extender’s Wi-Fi Settings” on the back instead.
If your router supports WPS, you can continue with the steps below to clone
its current Wi-Fi settings to the extender.
Tips: We recommend that you plug in the extender near your router for Wi-Fi cloning.
Press the WPS button
for 2 seconds.
1
Within 2 minutes, press
the Wi-Fi Clone button for
1 second.
2 Done.3
Wait until the Powerline
LED turns on.
Solid on for 5 seconds
and then blinks rapidly
WPSWAN LAN
Wireless Router
500Mbps
15
250
Blinks slowly for
about 10 seconds
To Next Page
