16
Chapter 3
Conguring via Web Management Interface
Copy wireless settings from my router to my extender, so I can use the same SSID and
password to access the internet in my house.
1. Before cloning, make sure your router supports the same band as your extender.
If you do not know how to check this, go to your router’s User Guide for more
information.
2. Plug your extender near your router.
3. Press the WPS button on your router.
4.
Wireless Router
WPS/
5. Within two minutes, press the Wi-Fi button on the front panel of the extender for 1
second. The Wi-Fi LED starts blinking.
Extender
Blinking
On
Wi-Fi
When the Wi-Fi LED blinks quickly for 3 seconds and then stays on, the Wi-Fi Clone
process is complete.
Note: By default, both band settings will be copied, but if you just want to copy one band settings, go to
Advanced > Wireless > Wi-Fi Clone, and select the band you want to copy then follow the steps above.
How can I do that?
Done!
To Next Page
Loading...
