Hello, I’m here.
Follow me to extend your Wi-Fi network.
TL-WPA8730
New Extender
TL-WPA8730
Existing Powerline Device
(For demonstration only)
1
Plug in the new extender next to one of your
existing powerline devices.
Check the new extender’s Powerline LED . Is it on?
2
Step 4>
Step 3>
Pair the powerline devices.3
Note: If the Power LED does not
blink, press the Pair button again.
Press the Pair button on the existing
powerline device for 1 second. The
Power LED starts blinking.
A Within 2 minutes, press the
Pair button on the new
extender for 1 second. The
Power LED starts blinking.
B
Note: A red Powerline LED indicates poor signal strength.
Move the extender to another location.
4
Relocate the new extender to the Wi-Fi “dead”
zone. Use the SSID (network name) and password
on the provided Wi-Fi Info Card to connect to the
internet.
If you cannot nd the SSID on the Info card in your
Wi-Fi list, this may mean the Auto-Sync feature
has automatically copied over the existing
wireless settings (see back for more information).
In this case, use the SSID and password of your
existing wireless network to connect.
When the Powerline LED on
the new extender turns solid,
the pairing process is complete.
C
within 2 minutes
Existing
Powerline Device
New Extender
TL-WPA8730
On
BlinkingBlinking