TL-WPA8730
Hello, I’m here.
Follow me to extend your Wi-Fi network.
Existing Powerline Device
(For demonstration only.)
Powerline
Press the Pair button on the new extender for
1 second. The Power LED starts blinking.
When the Powerline LED is on and stable,
the pairing process is complete.
B.
* If does not blink, press the button again.
Press the Pair button on the existing powerline
device for 1 second. The Power LED starts
blinking.
A.
1
Plug in the new extender in the same room with one of your existing powerline devices.
New Extender TL-WPA8730
Continue with the steps below.
within 2 minutes
Check the new extender’s Powerline LED , is it on?
Power Strip
Wall Outlet
Enjoy!
Tips: Please plug your powerline devices into wall
outlets on the same electrical circuit.
Proceed to Step .
* A red Powerline LED indicates poor signal strength, move the extender to another
location.
If you cannot find the SSID on the Info Card in your Wi-Fi network
list, which means the existing wireless settings have synced to
your new extender via the Wi-Fi Auto-Sync feature (see back for
more info), use the same SSID and password of the existing
powerline network to connect.
Relocate the new extender to the Wi-Fi “dead” zone. Use the SSID
and password on the provided Wi-Fi Info Card to connect to the
Internet.