- 52 -
• Protocol - The type of protocol the Router opens for the application.
• Internal Port - The Internal port the Router opens for local host.
• IP Address - The IP address of the UPnP device that is currently accessing the Router.
• Status - The status of the port is displayed here. “Enabled” means that the port is still
active. Otherwise, the port is inactive.
Click Refresh to update the Current UPnP Settings List.
4.9 Security
Figure 4-33 The Security menu
There are six submenus under the Security menu as shown in Figure 4-33: Firewall, IP Address
Filtering, Domain Filtering, MAC Address Filtering, Remote Management, and Advanced
Security. Click any of them, and you will be able to configure the corresponding function.
4.9.1 Firewall
Using the Firewall page, you can turn the general firewall switch on or off. The default setting for
the switch is off. If the general firewall switch is off, even if IP Address Filtering, DNS Filtering and
MAC Filtering are enabled, their settings are ineffective.
Figure 4-34 Firewall Settings
To Next Page
Loading...
