Note:
1. To use the DHCP server function of the Router, you must configure all computers on the LAN
as "Obtain an IP Address automatically".
2. When you choose the Smart IP (DHCP) mode in Network → LAN, the DHCP Server
function will be disabled. You will see the page as below.
5.3.5.2. DHCP Client List
Go to “Setting→DHCP→DHCP Client List”, and then you can view the information about the
clients attached to the Router.
Client Name - The name of the DHCP client.
MAC Address - The MAC address of the DHCP client.
Assigned IP - The IP address that the Router has allocated to the DHCP client.
Lease Time - The time of the DHCP client leased. After the dynamic IP address has
expired, a new dynamic IP address will be automatically assigned to the user.
You cannot change any of the values on this page. To update this page and to show the
current attached devices, click the Refresh button.
5.3.5.3. Address Reservation
Go to “Setting→DHCP→Address Reservation”, and then you can view and add a reserved
address for clients. When you specify a reserved IP address for a PC on the LAN, that PC will
To Next Page
Loading...
