TX-6610 1-Port Gigabit GPON Terminal User Guide
4
1.3.2 The Back Panel
Figure 1-2
¾ LAN: Through the port, you can connect the ONT to your PC or the other Ethernet network
devices.
¾ OPTICAL: The OPTICAL is where you will connect the fiber.
¾ RESET: There are two ways to reset the ONT's factory defaults.
Method one: With the ONT powered on, use a pin to press and hold the Reset button for at
least 5 seconds. And the ONT will reboot to its factory default settings.
Method two: Restore the default setting from “Maintenance-SysRestart” of the ONT's
Web-based Utility.
¾ POWER: The Power plug is where you will connect the power adapter.
¾ ON/OFF: The switch for the power.
To Next Page
Loading...
