7
Set up nbn
®
FTTC
1 Connect the power cables from your NCD and modem's Power Ports to electrical outlets.
2 Connect the included phone cable from the grey phone socket port on your NCD to your telephone wall socket.
3 Connect the included Ethernet cable from the blue WAN port on your modem to the yellow Gateway port on your NCD.
4 Make sure the electrical outlets for both devices are on, and press the modem's ON/OFF button.
5 Allow 20 minutes for your modem to boot up and connect automatically.
6 Check the lights on your modem. If the Internet light is green, you can start connecting your devices and getting online.
7 To plug in additional devices via Ethernet cable, simply connect the Ethernet cables to any of the four yellow LAN ports on your modem.
8 Turn to page 12 to continue your setup.
Power DSL 5GHzInternet4G 2.4GHz WPSPhoneWAN LAN 1 L AN 2 L AN 3 LAN 4 USB
ONOFF
DES-19417_VF_SMG_QSG_TPLink_Modem_NOV24.indd 7DES-19417_VF_SMG_QSG_TPLink_Modem_NOV24.indd 7 3/12/2024 11:09 AM3/12/2024 11:09 AM
To Next Page
Loading...
