Issue Date: 3-11-05 Rev. Date: 9-12-07 Rev. Level: 13 ECN: n/a OIPM P/N: 3420433
Page 2 of 8
Fan Specifications
Voltage (VAC) 120
Frequency (Hz) 60
Amps 1.5
HP 1/8
CFM 5750
Speeds 1
TPI Corporation’s self-contained power misting equipment is configured into three separate models:
An 18-inch fan head and pump enclosure. Model no. PM-18FO
An 18 inch fan head, pump enclosure, and 10 gallon cooler. Model no. PM-18S
An 18-inch fan head, pump enclosure, 10 gallon cooler and cart. Model no. PM-18C
MODEL:
• One 18-inch fan head with white powder-
guard mounted on a yoke attached to the pump
enclosure.
•
An integral ground fault circuit interrupter (GFCI)
is attached to the power cord.
• Equipped with a power cutoff tip switch.
• One extra nozzle and two plugs included.
•
Shipped in a single carton and ready to assemble to
your existing 10-gallon Igloo cooler.
Thank you very much for selecting TPI Corporation’s self-
contained power misting equipment for your comfort
conditioning needs. These products were engineered with the most reliabl
e components and materials available
and are equipped with features to assure ease of mobility, use, and maintenance.
The cool air you will now enjoy when using this misting equipment is created through the process of evaporation.
Heat is required to change water from a liquid to a gas or “water vapor”. TPI Corporation’s self-
misting equipment creates a “fog” by pumping water at a very low flow rate through small nozzles. When
combined with the air added by a fan, this fog is rapidly
evaporated. The heat required to evaporate the fog is
extracted from the air causing a reduced air temperature. This cooler air is then distributed to people or animals
creating a direct cooling effect.
The performance of your misting system can be aff
ected by local conditions. For best results, it may be
necessary to experiment with the number of nozzles operating to achieve the cooling performance you desire.
Thank you again and stay cool!
All Models
Voltage (VAC) 120
Frequency (Hz) 60
Total Amps 2.2
Pump output 2 gph @ 130psi
Misting hub 4 nozzles installed
Filter 50 mesh stainless steel
To Next Page
Loading...
Need help?
General
