If you wish to quit without accepting an alteration you have made,
press the button at any time.
Press the button again to leave the menu.
Menu point
Alarm select
In this menu point you can select whether the machine is to be switched
on automatically, and using which alarm.
Menu point
Set Alarm Time
Manual alarm time setting for the currently active alarm. Any change you
make at this point takes place slowly at first; holding the button pressed
in increases the rate of change.
Menu point
Set Alarm
Source
Selects the source which is to be switched on at the alarm time point.
If you select the menu point Radio, you can use the /
buttons to select a radio station from the Favourites list.
Waking to the radio:
Take care to set a station which can be received well.
Menu point
Set Alarm Vol.
You can set the alarm volume at this point. If you change the volume
setting, the system immediately accepts the displayed volume level, and
the change in volume is audible.
Menu point
Time Mode
This menu point is used to determine how the internal clock is set.
RDS If you select the menu point RDS, you can select a
radio station from the Favourites list using the /
buttons.
If you select the 'Any' setting, the time of day is read
out automatically from the RDS signal of the current
selected station, and adopted by the machine. This
occurs at night, and about three minutes after switching
on.
If you have selected a station, the time of day is
automatically read out from the RDS signal at night. If
the selected station is the current listening source, then
the time of day is adopted by the machine when
switched on.
This only works if high-quality RDS reception is
available.
It is now impossible to set the wrong time of day
manually!
Summer time The time of day can be set manually in the menu point
'Set time'.
Winter time The time of day can be set manually in the menu point 'Set
time'.
Menu point
Set Time
Manual method of setting the internal clock to the correct time.
Any change you make at this point occurs slowly at first - holding the
button pressed in increases the rate of change.
Manual adjustment is only possible if you have set Summer or Winter in
the menu point ‘Clock mode’.
Menu point
Disp.
Brightness
(Stdby)
At this point you can adjust the screen brightness in Stand-by mode to
suit your personal preference. The brightness setting becomes active
immediately. The ‘Off’ setting can only be selected if no alarm time is
active.
To Next Page
Loading...