First select the
Streaming Client function by pressing the
button.
Open the configuration menu with a long press on the button on
the F100 remote control handset. You should now see the configuration
menu on the front panel screen.
Use the / buttons in the menu to select the network
parameter to be changed, and activate the entry with the button.
You can now change the setting using the following buttons, depending on
the type of setting:
/ button for simple selection (ON / OFF)
Numeric buttons to for entering IP addresses
Alpha-numeric input for entering text
When the setting process is complete, or when you have entered the
complete address, press the button to confirm your action.
Alpha-numeric entry
At certain points, e.g. for entering server names or passwords, it is necessary
to input series of characters (strings). At such points you can enter letters,
numbers and special characters by repeatedly pressing the numeric buttons
on the F100 remote control handset, as when writing SMS news. The
assignment of letters to the buttons is printed below the buttons. Special
characters can be accessed using the and buttons:
0 + - * / ^ = { } ( ) [ ] < >
. , ? ! : ; 1 \ " ' _ @ $ % & # ~
Use the blue button for toggling between numbers, capitals and
lower-case letters. The bottom line of the screen shows which input mode is
currently selected.
At certain points (e.g. DNS server name) it is possible to enter both an alpha-
numeric string and an IP address. At these points an IP address should be
entered like a string (with separating dots as special characters). In this case
an automatic check for valid address ranges (0 … 255) is not carried out.
and Restart', then press the button. This action causes the
to
accept the settings, and the machine restarts with the new network settings.
After the restart you should see the available network media sources (Internet
radio, UPnP-AV server, etc.) displayed in the main menu.
At any time you can leave the network configuration menu without making
any changes to the network settings: this is done by pressing the
button, which takes you to the menu point 'Exit without saving'. Pressing the
button at this juncture interrupts and closes the menu.
To Next Page
Loading...