HELP
If you experience problems with your Trace Elliot unit please check the following before contacting an
authorised Trace Elliot dealer, distributor or service centre.
Symptom Check
Unit does not power up IEC mains cord is correctly connected.
Fuse in IEC inlet is OK.
Fuse in IEC mains cord is OK.
Unit powers up but no sound All connecting leads.
Signal level LEDs do not light Instrument leads and battery if applicable.
Signal level LEDs light but no sound OUTPUT LEVEL is turned above ‘1’.
Is MUTE or LOOP selected? If so,
turn off.
Leads in Effects Loop (7 Band).
No signal when LOOP selected (12 Band) Is it set SERIES? Set to PARALLEL.
LOOP LEVEL is turned up.
Connecting leads in LOOP.
External devices used in LOOP.
Unwanted distorted signal Is INPUT GAIN set correctly? Reset.
Is GRAPHIC set too extreme?
Is battery in instrument OK?
General purpose protection LED on Check Speaker wiring.
Is it overheating? Ensure vents are clear.
To Next Page
Loading...
