Need help?Do you have a question about the TRACE ELLIOT 715x and is the answer not in the manual?
Covers warnings about high voltage, opening the unit, rain/moisture exposure, and fire hazards.
Covers basic precautions like reading instructions, avoiding water, ventilation, heat sources, and proper plug use.
Details OSHA permissible noise levels and the need for hearing protection during operation.
Introduces the 12 Band and 7 Band ranges, highlighting differences in preamps, rear panels, and speaker configurations.
Explains the two categories of switchable features (pre-set vs. performance) and their operational characteristics.
Advises users to review caution and warning statements within the manual for safety.
A comparative table detailing features available in both 7 Band and 12 Band amplifier models.
Step-by-step instructions for connecting and powering on the amplifier for the first time.
Guides users on setting output level, exploring features, and adjusting gain based on signal LEDs.
Details the differences and signal flow on the front panels of 7 Band and 12 Band amplifiers.
Explains the input socket, HI/LO sensitivity switch, INPUT GAIN control, and signal level LEDs.
Covers the TUNER socket, PRE SHAPE, VALVE switch, DRIVE, and BLEND controls for tone modification.
Details the DI OUT socket, PRE/POST switch, and the Graphic Equalizer function for tone control.
Explains the 7 Band compressor's switch, rotary control, and its soft-knee, adaptive attack/release features.
Covers the 12 Band dual compressor switch and controls for low and high frequencies.
Further details the HIGH BAND control and the dual band compressor's soft-knee and adaptive features.
Explains SEND/RETURN sockets, LOOP switch, MUTE function, and OUTPUT LEVEL control.
Describes the multi-purpose red LED and the LINE OUT socket for preamp signal output.
Details the 8-pin DIN socket for connecting footcontrollers on 7 and 12 Band units.
Explains the DI EARTH LIFT switch and the SEND/RETURN connections for the 12 Band effects loops.
Details the LOOP LEVEL control and provides suggested configurations for using the effects loops.
Explains the 12 Band TUNER socket and the BALANCED DI OUTPUTS for connecting to mixers or stage boxes.
Details the unbalanced LEFT/RIGHT outputs and the Neutrik/1/4" speaker output sockets.
Covers the power switch, front panel brightness control, and IEC socket with fuse holder.
Explains the design of power amplifiers, including fans and protection features.
Describes the two-stage circuit designed to prevent power amplifier clipping and speaker damage.
Details features and configurations of Trace Elliot combo amplifiers, including speaker options and horn attenuation.
Provides a guide to common problems and their checks, such as unit not powering up or no sound.
Offers example settings for various sonic profiles like Classic Trace, Big Bottom, and Squashed Funk.
Illustrates the signal path through the 7 Band amplifier's circuitry.
Illustrates the signal path through the 12 Band amplifier's circuitry, including stereo aspects.
Details technical specifications like input sensitivity, impedance, EQ, compressor, and power output for both models.
Lists specifications for various combo models including transducer complement, power, impedance, and frequency response.
Provides dimensions and weights for different amplifier heads and combo units.
Explains various technical terms used throughout the manual, such as active, DI, FET, and soft-knee.
Continues defining terms like passive, ratio, sensitivity, series, and thermionic valve.
General| Brand | TRACE ELLIOT |
|---|---|
| Model | 715x |
| Category | Amplifier |
| Language | English |
To Next Page