The actual power level produced from the amplier will be dependent on the input signal and the settings of
the other controls.
Once set for a performance it can be left alone and the MUTE function can be used to turn the signal off
between songs or sets.
We also recommend turning the OUTPUT LEVEL control to ‘0’ at the end of a session, before switching
off.
(22) Multi-purpose red LED above OUTPUT LEVEL
This LED has several functions. Firstly, it will ash on and off if the MUTE function is selected. It will also
light momentarily if maximum output from the power stage is reached.
It also functions as a general protection warning light, illuminating if any of the following conditions occur:
power amp over-temperature protection, short-circuit protection, over-current protection. If this LED remains
lit please refer to the HELP section at the back of this manual.
(23) LINE OUT socket (7 Band)
This is an unbalanced jack output that can be used to send the output of the preamp section to another piece of
equipment, such as a power amplier, mixing desk or recording device.
The actual level is dependent on the setting on the OUTPUT LEVEL control, which means that if it is used
to expand the system with extra power amps and speakers, then the overall volume can still be set by a single
control.
To Next Page
Loading...
