(8) Now gradually turn up the OUTPUT LEVEL control. Do this slowly to avoid any sudden level changes
that could damage your hearing; these are loud amps! Set this at the desired playing volume.
(9) You will notice that the unit will have defaulted to a setting of everything off except the PRE SHAPE
circuit. This is so that whenever the unit is turned on it will power up with a good basic tone.
(10) Make music! Feel free to turn on and off the other features on the unit, either by the footcontroller or
the front panel, and make adjustments to the other controls to get an idea of the exibility of the unit. While
making adjustments keep an eye on the level indication LEDs; some extreme settings of the Graphic Equalizer
will increase the signal level into clip, if this happens simply re-adjust the INPUT GAIN control as mentioned
above.
To Next Page
Loading...
