Metalyser
®
Portable HM1000
Instruction Manual
v 5.0
Driver Installation
Your
Metalyser
®
is compatible with most computers with a USB socket, but first the USB
drivers may need to be installed. The drivers are located on the
Softwar
e
USB stick
provided for all versions of Windows post Windows
95.
Insert the USB memory stick into an available USB port on your PC
Connect
the USB cable supplied to the Metalyser
®
instrument as
described
for
battery
charging.
Connect the other end to an
available
USB port on your PC
Windows
will
run the ‘install new
hardware wizar
d’
When asked if
Windows can
connect
to Windows
update
to
search
for software.
Select
‘No, not this time’
Select
‘Install
from a list or specific location’, navigate to USB memory drive
Windows should install the drivers
Once
complete,
the wizard
will
run again. Use the same settings as
befor
e
Once Windows has installed the drivers, reboot
the
computer and your
Metalyser
®
should be installed
To
verify
correct installation select fast charge on the instrument and
check
that
the fast
charge
icon
(see
page 7) is
displayed
on the
Metalyser
®
’s
screen
Setting the Date and Time
The Metalyser
®
contains
a
calendar
and clock which is used to date stamp the
results
log.
The
clock may be set to UTC when you
receive
the
instrument
so may need re-setting. It
will also need re-setting if the battery is
disconnected.
To set the clock follow these steps.
From the main menu, select System
From the system menu, select Set date/time and press <OK>
Use the navigation key to alter the date and time
Press
<OK> when finished to save
settings
To Next Page
Loading...
Need help?
General
