Tracer SimRacer - PC and Console Connectivity; Xbox One Platform Setup; PC X-INPUT Mode Setup; PC D-INPUT Mode Installation

To Next Page

To Previous Page

Tracer SimRacer 6in1

Instructions for use

Note: This platform game currently does not support the function of 6+1 shift lever, so it is

better not to use shift lever.

6.4 XBOX ONE Platform Functions

1. Connect all the components of the system together: the pedals and the gearbox to the

steering wheel (rear plugs on the steering wheel module – shown on page 3 of the

manual). Connect the main steering wheel cable to the console’s USB port. Turn on the

console and steering wheel.

2. Connect the steering wheel with a 4-wire USB cable to the console controller to start

(the controller should be turned on).

3. Power on and start the XBOX ONE, and connect the main steering wheel to the USB

port on the XBOX ONE.

4. After successful boot, the LED on the steering wheel will light up, the indicator on the

XBOX ONE boot controller will also light up, At this point, you can perform related op-

erations on the host or enter the game.

5. In XBOX ONE console operation, press the MODE button on the steering wheel once

(equivalent to the original controller). To return to the main screen, hold down the

MODE key for 1 second to enter the shutdown setting screen.

6. On the Home screen, press Y on the steering wheel once to enter the Quick search

page.

7. In the game platform of XBOX ONE, you can share the screenshot of the game inter-

face by pressing the key.

8. After connecting the shift lever, it will automatically convert and lock into steering wheel

mode, which can only be enabled with game support and is not available in the game

Vibration and audio capabilities.

6.5 PC Platform Functions (No X-INPUT mode after connecting the shift lever, only steering

wheel mode

6.5.1 X-INPUT Mode (when no gear lever is connected)

1. Connect all the components of the system together: the pedals and the gearbox to the

steering wheel (rear plugs on the steering wheel module – shown on page 3 of the

manual). Connect the main steering wheel cable to the USB port on your computer.

Turn on the computer and steering wheel.

2. Power-on The default mode is X-INPUT, and the red indicator is steady on.

3. Hold down the MODE key for 3 seconds. After the LED blinks for 3 times, switch to the

D-INPUT MODE and hold down the mode key for 3 seconds. Switch to X-INPUT mode

again, and so on.

6.5.2 D-INPUT mode, Installation program

1. Access WINDOWS 7/8/10, insert the driver CD, double-click SETUP, and install the

driver as prompted The program. If you do not have a drive, you can download from the

www.tracer.pl/TRAJOY47245 website.

2. Insert the USB plug of the steering wheel into the computer to start control panel de-

vices and printers. Right click on the device game controller to set properties.