Tractel blocstop BSO Series

Questions and Answers

L
Lisa BurtonAug 13, 2025
What to do if Tractel Safety Equipment hoisting gear moves upwards but not downwards?
- C
  Charles SmithAug 13, 2025
  If the fall arrest device with limit switch moves upwards but not downwards, it could be due to a failed limit switch connection with the hoist controller. Try plugging in the connector. Alternatively, there may be a wire breakage, in which case you should have an electrician replace the wire. A defective limit switch may also be the cause, so have it checked by an electrician; if necessary, return the fall arrest device for repair.
C
collinstylerAug 17, 2025
How to open a stuck Tractel blocstop BSO Safety Equipment fall arrest device?
- R
  Ryan WallaceAug 17, 2025
  If the fall arrest device cannot be opened, it may be because it is holding the load on the safety rope. To resolve this, move the load upwards on the suspension rope. If that doesn't work, there may be a mechanical defect, in which case you should replace the fall arrest device and send it in for repair.
V
Veronica RobersonAug 20, 2025
Why won't the centrifugal force weight turn on my Tractel blocstop BSO?
- L
  Lindsey LeeAug 20, 2025
  If the centrifugal force weight does not turn, it could be due to soiling or a defect. In this case, replace the fall arrest device and send it in for cleaning or repair. Another possible cause is ice buildup. If this is the case, carefully use hot air to heat it up, ensuring the temperature does not exceed 70 °C.
D
devintranAug 25, 2025
What to do if the control pin is not visible on Tractel blocstop BSO BSO 2050/2360?
- R
  Ricardo SalasAug 25, 2025
  If the BSO 2050/2360 control pin is not visible after feeding in the safety rope, it could be because the rope was not fed in correctly. Try pulling the rope out and feeding it back in correctly. If the issue persists, there may be a mechanical defect, requiring you to replace the fall arrest device and send it in for repair.
L
Lori RyanAug 28, 2025
Why can't I feed the rope into my Tractel blocstop BSO Safety Equipment?
- C
  Christopher PerkinsAug 28, 2025
  If the rope cannot be fed in, it might be due to a faulty rope tip. Consider renewing the rope tips. Alternatively, the fall arrest device might be closed. In that case, open the fall arrest device.
M
Michael HortonAug 31, 2025
Why is the remote activation not working on my Tractel blocstop BSO?
- T
  Tammy AndersonAug 31, 2025
  If the remote activation does not function, it may be due to overheating. Check all connections on the system controller and correct them as necessary. Another possibility is an incorrect connector contact. In this case, have it checked by an electrician and repair if necessary.
S
Samuel ByrdSep 4, 2025
What causes speed difference in Tractel blocstop BSO and how to solve it?
- J
  Jacob SolisSep 4, 2025
  If the speed difference between the suspension rope and safety rope is too great when starting movement, it could be due to no tensioning weight on the safety rope. Attach a tensioning weight to resolve this.
R
Richard BrownSep 8, 2025
What happens if Tractel blocstop BSO Safety Equipment fall arrest device triggering speed is set incorrectly?
- D
  David TerrySep 8, 2025
  If the fall arrest device triggering speed is set incorrectly, replace the fall arrest device and send it in for repair.