Traeger BBQ055 - SECTION ONE: ASSEMBLY INSTRUCTIONS; MOUNTING LEGS AND WHEELS; MOUNTING PELLET HOPPER;BURNER

SECTION ONE: ASSEMBLY INSTRUCTIONS
MOUNTING LEGS AND WHEELS:
ch Leg, LEAVING NUTS LOOSE. Set
rill upright to level and then tighten all nuts.
OUNTING PELLET HOPPER/BURNER:
OT remove the white, square Burner Gasket (86) from the Hopper/Burner
(37).
1)
Body (3)
until the Hopper/Burner (37) is snug against the end of the Grill Body (3).
) Align the bolt holes in the Grill Body (3) with the Nut Serts in the Hopper/Burner (37).
3) rill
(37) Nut Serts.
Tighten all four Bolts – DO NOT OVER TIGHTEN THE BOLTS.
PHILLIPS SCREWS
WITH FLAT WASHERS
AND HEX NUT
NOTE: Install all Leg Screws and Nuts, 3 in ea
G
M
NOTE: DO N
Slide the Hopper/Burner (37) square tube into the square opening located on the left
side of the Grill Body (3). Gently push the Hopper/Burner (37) into the Grill
2
Install a Flat Washer on each of the four Hex Head Bolts. From the inside of the G
Body (3) install these Bolts with Washers into the Hopper/Burner
LEG WITH HOLES FOR
XLE/WHEELS
N
YLOCK NUT OUTSIDE
A
FLAT WASHER BETWEE
WHEEL AND LEG AND
BETWEEN WHEEL AND
N
LEG WITH
BOTTOM CAP
AXLE ROD
S INSIDE
(3 PER LEG)