INTRODUCTION
CONGRATUALATIONS on your purchase of this Traeger COM150. With the proper set-
up, operation, and maintenance, this grill will provide years of cooking performance.
READ THESE INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO FINISH
ASSEMBLING YOUR GRILL.
SET-UP:
Your Traeger com 150 comes almost completely assembled You will need to
complete the assembly by:
1) Installing the four swivel casters.
Tools required for the assembly of your COM150
1 3/4" Box end wrench
1 1/4" Wrench or nut driver
1 Pair of pliers
When you un-box your grill, make sure you have, and can identify the following parts:
(2) Grease drain pan (4)
(2) Porcelain coated grill (3)
(2) Grease bucket (8)
(2) Heat baffle (5)
(2) Swivel caster with brake(16)
(2) Swivel caster without brake (2)
NOTE: THE NUMERALS FOLLOWING PART NAMES THROUGHOUT THIS
MANUAL REFER TO THE COMPONENT DIAGRAM ON THE PREVIOUS PAGE.
Follow these step by step instructions and you’ll be cooking in no time!
To Next Page
Loading...
