85
Tighten lug nuts securely.
86
Bend and cut cotter pin in wheel hub.
Repeat Steps 83-86 on driver’s side.
87
You will need a valve stem tool to
tighten all valve stem cores. This tool
can be purchased at an auto parts store.
88
Tighten all valve stem cores.
89
Using a low pressure tire gauge, set
tires at 10 psi for front and 8 psi on
rear. Install valve stem caps.
90
Remove the acid container from the
top of the battery and properly dis-
card. Set the plastic cap (from Step 9 ) into
the top of the battery making sure that ...
To Next Page
Loading...
