3.
Put the lap portion of the belt low on
your hips. Push down on the buckle end of the
belt as you pull up on the shoulder part so the
belt is snug across yourhips.
4.
Position the shoulder belt over your shoulder
and across your chest. The shoulder belt
shouldfitagainstyourchest.Ifitisloose,
pull the belt out all the way and then let it
retract.
5. To release the buckle, firmly press the
release button.
WARNING
POTENTIALHAZARD
Not wear the seat belt, and wear the seat beltimproperly.
WHAT CANHAPPEN
There is increased risk of being killed or seriously injured in an accident.
HOW TO AVOID THE HAZARD
Always wear your seat belt when riding in the vehicle. Be sure the seat belt is close‐fitting across
your hips and chest and is latchedsecurely.
1. Spring preloaded adjustingring
2. Positionindicator
Rear shock absorber adjustment
The spring preload can be adjusted to suit the
operating conditions.
You can reduce preload for a softer ride, or
increase preload if frequent bottoming occurs.
Adjust the spring preload as follows.
-
To increase the spring preload, turn the
adjusting ring in direction of”A”.
-
To decrease the spring preload, turnthe
adjusting ring in direction“B”
!WARNING
Frequent or severe bottoming can cause
increased wear or damage to the vehicle.
To Next Page
Loading...
