Product Design:
The Concrete Encounter CME 4 is
a hand-held electronic moisture
meter operating on the principle
of non-destructive impedance
measurement. Parallel co-planer
electrodes are mounted on the
base which, during operation,
transmit low-frequency signals
into the concrete floor screed to a
depth of approx. 12.5mm (.5 inch).
While concrete under normal
conditions can never be
completely dry, the instrument
has been calibrated on acceptably
dry material. In operation it
compares the change in
impedance caused by the
presence of dampness and
displays this on a clear, easy to
read analog dial.
Operating Procedure:
To carry out moisture tests simply
brush any dust from a smooth
area of concrete and also from
electrodes, switch on the Concrete
Encounter CME4 and place firmly
onto the surface, fully
compressing the spring loaded
signal enhancing contacts on the
base. Read the moisture content
from the clear analog dial.
The CME 4 is calibrated to give
percentage moisture content
readings on a clean, bare dust free
concrete floor slab. Thus, readings
taken on concrete slabs through
paint, coatings, adhesives or other
materials on the surface should be
regarded as qualitative or
comparative and not quantitative.
DON’T TAKE RISKS WITH
EXCESS MOISTURE!!
Moisture test before you
install a floor covering
Excess moisture in concrete
substrate can cause costly
problems for the installer. Avoid
the risk of having these problems
and floor failures by testing for
excess moisture before installing a
floor. Test the fast, easy, clean and
non-destructive way with
CONCRETE
ENCOUNTER CME 4
There’s absolutely no surface
damage and no waiting!
DISTRIBUTOR:
Concrete Encounter CME 4
Features:
•Instant Readings
•Non-destructive in operation
•No need to probe or drill or
mechanically damage the
surface
•Reproducible results
•Battery Operated
•Pocket Sized
•Clear, easy to read
analogue dial
•Strong, robust, electrodes
and body
•Reading Hold function
Power On
Power On LED
BASETOP
Battery
Member
FOR MORE INFORMATION ON THE ABOVE OR ANY OF THE TRAMEX RANGE OF MOISTURE
MEASUREMENT AND DETECTION INSTRUMENTS PLEASE CALL, FAX, E-MAIL OR WRITE TO:
TRAMEX LIMITED
Station House, Shankill Business
Center,
Shankill, Co. Dublin, Ireland.
Tel: +353-1-282 3688
Fax: +353-1-282 7880
E-mail: sales@tramex.ie
U.S.A and CANADA - TRAMEX
LIMITED
c/o Black Hawk Sales Inc.
28 Pin Oak Drive, Littleton, CO 80127
Tel: 303 972 7926
Fax: 303 972 7106
E-mail: dennisw@tramexltd.com
Web Site:
www.tramexltd.com
FLOORING MANUF
ACTURERS RECOMMENDED
Co.-planer
Electrodes with
special spring
loaded contacts
to enhance
signal depth
and sensitivity.
Signals are transmitted into the Concrete
Product Data Sheet – CME 1004
Hold - Flashing LED
Hold On/Off
To Previous Page
Loading...
Need help?
General
