21
MEP USER GUIDE
Requirements for quality management and valida-
tion procedures, such as ISO 9001, have increased
the need for regulation and verification of measuring
and test instruments. It is therefore recommended
that calibration of the MEP should be checked and
certified in accordance with the standards and/or
protocols laid down by your industry (usually on an
annual basis) by an authorized test provider. The name
of your nearest test provider and estimate of cost is
available on request.
Warranty
Tramex warrants that this instrument will be free
from defects and faulty workmanship for a period
of one year from date of first purchase. If a fault
develops during the warranty period, Tramex will, at
its absolute discretion, either repair the defective
product without charge for the parts and labour, or
will provide a replacement in exchange for the defec-
tive product returned to Tramex Ltd
This warranty shall not apply to any defect, failure
or damage caused by improper use or improper or
inadequate maintenance and care.
To Next Page
Loading...
Need help?
General
