4
MEP USER GUIDE
• Supply timeout is automatically extended if a
change in meter reading is detected or if any
button is pressed.
• 10 second bleep warning on instrument sounder
prior to end of supply timeout period.
• Last used scale is memorized at supply timeout
and automatically selected next time ON/OFF
button is pressed.
• Three LEDs (light emitting diodes) show selected
scale, indicate if HOLD/AUDIO selected and
provide warning of battery nearing end of useful
life.
• HOLD/AUDIO button freezes moving coil meter,
which facilitates readings taken out-of-sight.
• If HOLD/AUDIO was selected prior to supply
timeout, the frozen meter reading is digitally
memorized and restored next time ON/OFF is
selected.
If the battery voltage is getting low, the three
LEDs will flash sequentially for a short period.
The instrument will continue to operate for
some time but it is recommended that the
PP3 (9 volt) battery be changed as soon as
convenient.
To Next Page
Loading...
