TRAMEX Moisture Encounter Plus User Manual

6
MEP USER GUIDE
OPERATING INSTRUCTIONS
1. Press the ON/OFF button to power up. The LED
for the last used scale will light.
2. To change scale, press/release the SCALE button
until the LED opposite the required scale lights.
3. Hold your Moisture Encounter Plus directly on the
material being tested ensuring both conductive
rubber electrodes are fully in contact with the
surface.
4. For wood or wood products read the moisture
content from the upper line (Wood) of the meter
dial which is marked from 5% to 30%. Audio sig-
nal will sound when meter indicates high reading.
5. To turn audio signal on or off, press HOLD/AUDIO
button twice in quick succession.
6. For drywall, felt roofing, plaster or brick compara-
tive (Relative) readings are taken from the lower
line on the meter dial, which is marked from 0 to
100.
7. The instrument will automatically power-off after
ten minutes if no button is pressed or if no change
in meter reading is detected. If a button is pressed
or the meter reading changes, the power-off will
be extended for a further ten minutes.

TRAMEX Moisture Encounter Plus Specifications

General

Brand	TRAMEX
Model	Moisture Encounter Plus
Category	Measuring Instruments
Language	English