NON DESTRUCTIVE MODE
•
•
•
•
•
•
•
•
The built-in Relative Humidity Sensor provides
Temperature, Relative Humidity, DewPoint and
grains per pound readings.
Automatic power timeout (5 mins) conserves
battery life
.
Shortcut Menu: To choose between scales in
Non-Destructive Testing (NDT), or Recently Used
Wood scales in Pin-Meter Mode, press ,
scroll and to select and return to main
screen.
Full Menu: Press to access Full Menu,
and to scroll, to select, and to exit
menu to main screen.
Full Menu is used to choose NDT and Pin Scales
(Wood Standard, Wood Species, WME, Drywall),
Pin Temperature, Language and Temperature
Scale (Cº of Fº). For complete instructions, see
the online user guide.
Last scale used is memorized on power off and
automatically restored on next power up.
Hold/freeze: Press once, “II” will appear on
the screen. Press again to release hold.
(If powered down while on Hold, will retain infor-
mation until powered up and hold pressed again
to release)
CONCRETE %MC scale: Quantitative %MC
Moisture Content by mass/weight readings for
Concrete slabs and sand/cement screeds using
Gravimetric testing as a baseline.
CM CONCRETE scale: Equivalent reading to
Carbide Method (CM) test for Concrete slabs and
Sand/Cement screeds.
CM ANHYDRITE: Equivalent reading to Carbide
Method (CM) test for Anhydrite, Hemi-hydrate,
Gypsum and Calcium Sulphate Screeds.
GYPSUM REF 0-12: Reference readings repli-
cating measurements using concrete scale on
concrete & sand/cement floors/screeds, for use
on Gypsum floors/screeds.
REFERENCE 0-99 scale: Comparative/qualita-
tive scale to identify areas with moisture; where
direct contact to bare concrete is not possible
due to thin coating or covering; for non-concrete/
screed materials such as ceramic tiles or stone.
To Next Page
Loading...
Need help?
General
